TUBE DIFFUSERS
Tube diffusers are normally fitted into preassembled self-supporting units, easy to transport and install. These systems use square-section tubes in stainless steel, which at the same time feeding the diffusers with air and creating the support system.
The number of diffusers and the dimensions of each system are customised to the requirements. Micro-perforated membrane combines high efficiency in the transfer of oxygen and low head loss.
The most common material for the membranes is EPDM, however, membranes made from alternative materials are available upon request and used for applications in particularly aggressive wastewater.
Brand: SCM
Country of Origin: Italy
- 65mm diameter and 25mm threaded connection.
- Lengths in 1000mm, 750mm and 500mm.
- Connectors for box section mounts available sizes 60×60, 80×80, 100×100.
- Airflows up to maximum of 20 Nm3/hr per unit.
- Recommended operating range 1 – 12 Nm3/hr per unit.
PANEL DIFFUSERS
Panel / Strip
The panel diffusers provide microbubbles maximising the transfer rate of the oxygen thanks to the large area of the high efficiency polyurethane membrane, ensuring very low maintenance costs and high transfer yields. This provides a saving in the amount of air consumed and a lower energy and operating cost of the aeration system (a gain of +20% on kgO2/kWh compared to traditional systems of disc and/or tubular diffusers).
When using Panel / Strip diffusers, it is possible to cover the same surface with a smaller number of units. The panel diffuser with its modular structure allows for strips of different lengths to be assembled. The special mounting supports allow for direct installation to the bottom of the tank without the need for a support structure.
Brand: SCM
Country of Origin: Italy
- Pore density of 28.4 pores/cm2, with pore size smaller than 0.3 mm.
- Each diffuser has an internal check valve.
- A gain of +20% on kgO2/kWh compared to traditional systems.
- Standard lengths of working area 1.5m to 4m.
- 32mm Connections on single end or both.
- Easy to use mounting points for direct fixing or fixing to lifting frames.
DISC DIFFUSERS
The micro-perforated membrane combines high efficiency in the transfer of oxygen and low head loss. The most commonly used material for the membranes is EPDM rubber, however, silicone is available upon request for applications in particularly aggressive wastewater.
The disc diffusers may be supplied loose, or organised into systems or networks. S.C.M. Tecnologie’s technical department design aeration systems with diffusers for different types of tanks and treatment providing us with recommendations to fit the customer requirements.
Brand: SCM
Country of Origin: Italy
- EPDM and Silicone membrane materials.
- 30% GF Polyproplyene base.
- 2 sizes – 270mm and 340mm diameters.
- 20mm and 25mm connections.
- Optional non-return valves.
- 1.5 – 12 Nm3/hr recommended flow range – max 15 Nm3/hr.
BUBBLE DIFFUSERS
Course Bubble
These diffusers are stainless steel and can be considered the perfect solution for applications that do not require a remarkable oxygen transfer but rather a mixing action.
Course bubble diffusers are successfully used in sand and oil separation processes. Their particular open non-clogging structure and the base material ensure resistance to corrosion and long life. The coarse bubble diffusers can be arranged as preassembled self-supporting structures, that can be easily transported and installed.
Brand: SCM
Country of Origin: Italy
- Corrosion resistant stainless steel manufacture in 304 or 316 grades.
- Length is 450mm x 50mm wide.
- Recommended range 18-25 Nm3/hr – max 53Nm3/hr.
- Suitable for aggressive and unusual applications.
- Excellent mixing action, low O2 transfer rate.